Our Communicator Unit has been specially developed with the aim of preventing dust and water from entering its interior. Each component was chosen based on the minimum requirement of obtaining an IP67 system.
The design of the front panel has been conceived to make water tight between the panel and the protective/transport case that contains all the electronics. The front panel is provided with an O-ring which makes a radial seal between the panel itself and the protective case.
We have developed a modular system capable of being reconfigured in order to have batteries of different capacities based on operational needs.
The 2 Diver Comms Unit design facilitate the maintenance and identification of any problem. We have created a series of electronic boards becouse we wuold like to reduce the amount of wiring inside the unit. Where possible each specific group of components on the front panel has been connected to a dedicated board. Through the use of this solution we have succeeded in creating a linear and easy-to-use system.
By the use of two battery we have created a redundant systems. The unit is design also to have both the possibility of operating connected to the electrical network and / or to a 12VDC source. A control of the system is made by a battery board which control the correct battery charging cycle and status. We have also a board that identify which of the diver is talking, and, directly control a led on the front panel.
